316 Stainless Steel Sheet, Unpolished Mill Finish, Annealed/Hot Rolled, ASTM A240, 0.1875″ Thickness, 12″ Width, 12″ Length

Small Parts 43775 - Machinability describes how easily it can be cut, finished, or otherwise machined, shaped, while weldability characterizes the ability to be welded. Magnetism characterizes how much the material is repelled by or attracted to a magnet. The precipitation-hardening PH class can be heat treated after fabrication to achieve some of the highest hardness ratings in stainless steel.

The martensitic class includes some of the hardest and strongest stainless steel grades that also offer mild corrosion resistance, high hardness, and good formability. Tensile strength, used to indicate the material’s overall strength, is the peak stress it can withstand before it breaks. An austenitic stainless steel, 316 is typically nonmagnetic and can be cold worked to increase its hardness and strength while maintaining most of its formability.

Formability indicates how easily the material can be permanently shaped. The 316 stainless steel grade provides better corrosion resistance than general-purpose 304 stainless steel, especially in marine environments, due to higher nickel content and the addition of molybdenum. The chemical composition of each grade creates a grain structure that falls into one of five classes: austenitic, ferritic, duplex, martensitic, and precipitation hardening.

316 Stainless Steel Sheet, Unpolished Mill Finish, Annealed/Hot Rolled, ASTM A240, 0.1875" Thickness, 12" Width, 12" Length - Annealed after shaping to modify the metal's properties. Wear resistance indicates the ability to prevent surface damage caused by contact with other surfaces. Toughness describes the material's ability to absorb energy before breaking, while hardness commonly measured as indentation hardness describes its resistance to permanent surface deformation.

More information about Small Parts 43775

Ancor Marine Grade Wire & Battery Cable 18 AWG – 4/0 AWG and Spool Sizes

Ancor Wire and Cable 112502 - Vinyl insulation stays flexible in extreme cold. The wire's exclusive insulation is rated at 600 volts, 221° F / 105° C dry and 167° F / 75° C wet, and is engineered to withstand heat and abrasions. Exceeds all ul 1426, us coast guard charter boat CFR Title 46, and ABYC standards. Resists salt water, oil/gas, battery acid, UV rays.

Rated at 600 volts; withstands heat/abrasions. Ultra-flexible Type 3 stranding helps prevent fatigue due to vibration and flexing. Ancor's proprietary premium vinyl insulation stays flexible even in extreme cold -40° F/ -40° C and resists salt water, gasoline, battery acid, oil, and ultraviolet radiation.

Ancor Marine Grade Wire & Battery Cable 18 AWG – 4/0 AWG and Spool Sizes - Ancor marine grade primary Wire is manufactured from tinned copper stranding for maximum protection against corrosion and electrolysis. Prevents fatigue due to vibration and flexing.

More information about Ancor Wire and Cable 112502


Similar products